APPENDIX A: CHANGING DIP SWITCH SETTINGS

NOTE: ALL DEFAULT SETTINGS ARE FOR THE ELECTROBRAID 2.5 JOULE ENERGIZERS. FOR THE CORRECT SETTINGS FOR OTHER ELECTROBRAID ENERGIZERS, CONTACT US AT 1-888-430-3330.

A.1 LOCATION OF SWITCHES: If changes in Dip Switch Settings are required, you must first disconnect the power supply. Then, remove the back cover and you will see two banks of Dip Switches (8 switches each) located on the main electronic board. These are SW-1 and SW-2 (see diagram).

Board Schematic - to Locate Dip Switches

A.2 DEFAULT SETTINGS FOR SWITCH BANK SW-1 (oriented per the schematic):