1) Disconnect the energizer from the fence.
2) Connect the energizers to the Fence Minder.
3) SW! switches 4,5, & 6 MUST be set to OFF
4) Using a small length of wire (5" to 6"), connect the ENABLE terminal to the (-) battery terminal on the Fence Minder™.
5) Power the Fence Minder™.
6) Press the Reset button.
7) Remove the small length of wire from the terminals.

The yellow LED will remain lit until your energizer's voltage Count is saved to EEPROM after which the unit will resume normal operation. The yellow LED should blink in rhythm with the energizer pulse; if not, please call us and let us help you trouble shoot the problem.

A.2.3 DEBUG MODE
The amount of data output on the serial RS232 port when the Fence Minder™ is running is set using SW1-7, SW1-8. This is only to be used by a trained technician.

Setting	Low	.2.	.3.	High
SW1-7	Off	Off	On	On
SW1-8	Off	On	Off	On

Default settings are SW1-7 Off; SW1-8 On

A.3 DEFAULT SETTINGS FOR SWITCH BANK SW-2 (oriented per the schematic):

Note: The white block indicates the position of the switch

A.3.1 UN-INTERRUPTED ENERGIZER OPERATIONS:
SW2-1 is set to Off: the energizer power will be turned off by an Alarm Type 1 (a sudden drop of voltage).

Default settings is OFF