Running your lines

Pick up the reel and walk your fence line. At each line post, fasten the strand of ElectroBraid™ to each insulator.

DO NOT take off one end of the spool. The Braid™ will kink and could be damaged. The correct method is to unroll the Braid™ and it will not kink (see diagram. Continue unreeling the Braid™ until you come to an end post where the strand will terminate. End the strand by attaching it to the end insulator just as you did when you started the strand. Pull hard on the Braid™ to remove as much slack as you can before you apply the tensioning device. Clamp the ElectroBraid™ to itself using a copper split-bolt connector approximately 2" from the insulator.

NOTE: When installing fence on rolling terrain tension all lines first before attaching the Braid™ to the dip and ridge posts.

Dip Post

A Better Way to Fence Your Horse